|
|
|
#37
04-07-2024, 07:02 AM
|
||||
|
||||
I put a different clutch arm in. The one it had was not matching the rest of the linkage. I looked it up. Trucks and big impalas. 11 inch heavy duty. 1.5 inch difference in the pivot points.
So I am about to get her out and test. I replaced the motor in the vac pump it held up. It was flooding last time I adjusted the floats. New rear main seal. It seems to not be the Juan Valdez anymore. New rad cap. Put in a catch can. PCV system was increased to 3/4 inch inside diameter. 
|
|
|
Threaded Mode