UPDATE: The 383 is gone. I sold the longblock for 2K. Kind of cheap, but I needed it gone. ;)

I also got the trans tunnel opened up and mounted the transmission for mock up.

Tunnel was opened up 4" total to make room for this T56

http://www.allenitllc.com/hotrods/ch...1/DSCF3028.jpg

http://www.allenitllc.com/hotrods/ch...1/DSCF3029.jpg

I've still got some more work to do, but it's getting there.

http://www.allenitllc.com/hotrods/ch...1/DSCF3033.jpg

Crossmember worked perfectly without modification.

http://www.allenitllc.com/hotrods/ch...1/DSCF3032.jpg

Nice work, your set up is looking good.

wow nice work man! i like it! get it done so i can see it and get mine done like that :) only thing is mine will be a 408 lq9 :)

I finished up the tunnel last weekend. Made the very rear removable with rivnuts. This will allow me to pull the cover so the trans can be removed separately from the motor if I need to work on it.

http://www.allenitllc.com/hotrods/ch...new-tunnel.jpg

Tunnel complete
http://www.allenitllc.com/hotrods/ch...unnel-done.jpg

This weekend I started off by getting my hydraulic clutch setup working. I bought a bracket off of ebay that mounts the clutch master cylinder and then installed my 1964 clutch pedal. I welded a tab onto the clutch pedal to connect the hydraulic clutch rod to my pedal.

http://www.allenitllc.com/hotrods/ch...1/DSCF3059.jpg

http://www.allenitllc.com/hotrods/ch...1/DSCF3060.jpg

http://www.allenitllc.com/hotrods/ch...1/DSCF3061.jpg

http://www.allenitllc.com/hotrods/ch...1/DSCF3062.jpg

Got some goodies in the mail and started my fuel system.
http://www.allenitllc.com/hotrods/ch...uel-supply.jpg

Walbro 255 fuel pump mounted behind fuel cell
http://www.allenitllc.com/hotrods/ch...1/fuelpump.jpg

Corvette filter/regulator mounted up. Fuel system is now complete
http://www.allenitllc.com/hotrods/ch.../regulator.jpg

Drilled and tapped my water pump for the steam vent.
http://www.allenitllc.com/hotrods/ch...teamvent-2.jpg

Drilled and tapped for oil pressure gauge.
http://www.allenitllc.com/hotrods/ch...l-pressure.jpg

And started working on my harness. Hope to start it next weekend! ;)

http://www.allenitllc.com/hotrods/ch...s1/harness.jpg

wow good job man i am very jealous!

Same here.

And I love the idea of being able to pull the motor or trans separately. Great Job.

Looks good ,keep up the fun work .

Looking good, keep sending pictures