Checked the block to piston clearance and everything looks great. Sent the crank out to be turned and polished looks like it's going to be .020 .020 when done.
I did pick up a set of Solid rollers (Isky Red Zones) the only concern is they are offset (intake) the guy I bought them from (John Lukovich) said they will be fine for my stock setup. said he uses them all the time because they have less angle on the pushrod angle.
Also picked up a set of Pro Magnum roller rockers. If I decide to keep the solid roller I'll put in a stud girdle.
I'm in no hurry to get this thing done but when I find some parts...I pick them up.
When I get all the parts and finally figure out the combination I'll post some pics.
|