[Berg]

I got some more stuff coming on the way. It took me a while with other things going on to finally get some stuff taken care of. I got rid of a few more projects and made some more room in the garage. I'm able to fit 2 cars in the 3 car garage! It is an improvement. I'm not even able to fit a car in the middle bay even if everything was out of it because there is only 16' from the back wall to the door opening. It seems like my Chevelle always takes a back seat to projects like baseboard moldings and door trim in the house. I also had a roof leak and a window that was so out of square it was binding up and not able to latch shut. I still have a door to take care of on the back of the garage too and new steps and a patio where the deck used to be. I broke down and got a 3899621 bellhousing for the 11" clutch. I was going to use a 10.5" clutch behind the 454 I'm putting in because of the low power output but had a change of heart. I had gotten a 3858403 housing but I'm going to stack it into the spare parts bin along with the extra 12 bolt rear and spare disc brake spindles. I might end up selling this stuff once the car is together to get some more funding and space in the garage. I ordered a partial trunk pan to take care of the hole and rust around where the cutout was for the fuel cell sump. I ordered a new cross shaft rebuild kit to help tighten up the Z bar. I'm going to weld up and re-drill the holes for the linkage to take some slop out of it. I opted to get as many used GM and NOS parts as I could so I could ensure they'd fit as original. Its going to be a rainy week so I don't see the car getting pulled out for a little while.