|
|
|
#1
01-04-2014, 02:26 AM
|
|||
|
|||
holley carb return spring
Looking for any help on the right/stock return spring setup on my car. 1966 396/360hp,powerglide. Ran all the #s and its the stock holley intake and carb. The return spring is on a bracket mounted off the front top valve cover hold down bolt. Its also chrome so I know its not right. also looking for a stock air cleaner. I bought a stock one but its for a q-jet.
|
|
#2
01-04-2014, 06:00 PM
|
||||
|
||||
|
Wish I could help. I have a Holley carb but it's not stock. Mine has a bracket mounted to the driver's side rear carb stud, same bracket the throttle cable is attached to.
|
|
#4
01-05-2014, 07:06 AM
|
||||
|
||||
|
I don't know anyone with a 66 or I'd have them take a pic. Everyone I know has 68 or newer.
|
|
#5
01-05-2014, 08:50 AM
|
||||
|
||||
|
Might be this one bracket http://www.ecklerschevelle.com/cheve...1966-1968.html
Think i saw one today, 66 bbc chevelle. The bracket was bolted to the front alt bracket in the front of engine. Like this
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 01-05-2014 at 10:54 PM.
|
 |
|
|
Linear Mode
