|
|
|
|
|
#1
05-09-2012, 09:52 AM
|
|||
|
|||
Got it completely torn down yesterday...
   very glad I did.  
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi 
|
|
#2
05-09-2012, 09:53 AM
|
|||
|
|||
|
Spent the rest of the afternoon stripping and priming the driver's side frame rail.
  Today's agenda - remove old bushings, strip and primer these... 
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi
|
|
#3
05-09-2012, 02:11 PM
|
||||
|
||||
|
I would put ball joints in it while you got it apart.
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#4
05-09-2012, 04:22 PM
|
||||
|
||||
|
Made progress on the electrical. Got my dash lights working after replacing the light switch. Heater works if I wiggle the switch, so time for a new switch. Still have no tail lights. Need to check the ground, I'm hoping thats the problem.
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#5
05-09-2012, 07:19 PM
|
||||
|
||||
|
Made arrangements to have the new EFI installed and the air conditioning installed. I will be checking with NPD to see if they have them in stock. Should have my car at the shop early next week.
WOO HOO !
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#6
05-09-2012, 08:40 PM
|
|||
|
|||
|
It was a real chore to uncover him and drive 10 miles to get him up to operating temperature and change the oil and filter on Sunday.Sometimes I wonder if it is really worth keeping the car.
|
|
#7
05-09-2012, 10:28 PM
|
||||
|
||||
|
Dash lights tonight, looks like the intermediate harness might be bad. tail lights work fine with a jumper wire from the wire before the harness. I hope it's not bad, to replace it means removing half the interior out of the car.
 
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#9
05-10-2012, 08:02 AM
|
|||
|
|||
|
finally i spent some well needed time working on the chevelle! i put the door panels on with the arm rest all i need are new pad. also put on the window cranks and the door cranks. then i installed the dash which i am sure i am going to have to take off again. now the dash is in and all wired just missing three parts from there. and i will make a thread about it..lol
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
