|
|
|
#4
02-27-2012, 07:57 AM
|
||||
|
||||
Do you have the following?
ENGINE Fuel Pump Fuel Pump Push rod Fuel line from pump to carb If Holley, carb fuel line kit Thermostat Housing Heater Hoses & clamps Fittings for intake for heater hoses Vacuum fitting for back of intake if necessary Plugs, wires & distributor/coil Throttle linkage brackets Trans kick down bracket (if TH350) PCV valve & hose Breather for valve covers Oil fill cap Power steering? Pump, belt & lines Exhaust (headers or manifold) gaskets & hardware Starter REAR Gear oil x3 bottles I have that same basic cover and when using the gasket mine seeped oil. I took it out and used a bead of sealant instead. Just an FYI. I would get new rear wheel cylinders if you are replacing everything else in the brakes Just a few items to think about.
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode