Mega shifter with stock console help

[jays 1971]

I glad I could be helpful. I actually have everything apart now so I'll try to get a picture of the shifter plate without the boot in place if that would be helpful. One thing I can say is to put something between the console and plates to protect the console from scratches while your fitting the plates. I just used some #10 stainless screws to hold everything down. If you dont plan on putting the original center secton in then I would level off the center tabs so that the plates are even. I can't think of anything else I ran into during the install right now. I hope that this helps you out.