The '64 Chevelle SS tribute build thread

[earthquake68]

Here's the pictures as promised.

Here's my new drive shaft. Cleaned up, painted and new u-joints.



And here's the shot I've been promising about inside the trunk. I finally got the trunk speckle painted today. It turned out well, but it was a lot more involved than I thought it would be. It's also a lot more toxic than anything I've ever used before. I can usually put up with any kind of paint fumes, but this stuff is nasty.



...and this is my passenger side exhaust manifold. This turned into a disaster quick. I wanted a three bolt flange manifold without any A.I.R. tube bosses or a flange for a heat stove or heat riser. Such a manifold is extremely rare. I found one, but it was broken into three pieces, had three bad studs and an extra boss for a single A.I.R. tube on the front cylinder. After 5 hours, I can use it. Whew!