ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Garage > Chevelle Interiors

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 09-23-2013, 07:38 AM
Hank70SS's Avatar
Hank70SS Hank70SS is offline
Moderator
 
Join Date: Dec 2009
Location: Brighton, MI
Posts: 4,719
Default

You'll probably have to remove the parking brake pedal to remove kick panels. If an AC car is the same, grill pops out of kick panel, screws that hold it in are behind the grill. Make sure you apply plenty of caulk around vent when you put the kick panel back in. Water from cowl runs through that area and out bottom of fender. Any leaks and it will run inside and under carpet.

If new carpet is a lot bigger than needed, mine was, use old as a template to get it a little closer to the correct size. Mine was so oversized you couldn't even fit it in under the dash. If the hump over the trans tunnel is to big, common complaint with replacement carpet, you can slit it down the middle and remove some of the excess. I had to do that with mine, console covers it and holds it in place, you'd never know it was slit.
__________________
Hank

70 Chevelle SS396(454), M20, 3.73
My Chevelle
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:01 AM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Audiokarma.org