|
|
|
#14
03-13-2022, 05:49 PM
|
|||
|
|||
I had to put all of the studs in the housing. They’re knurled and I just used a nut and some washers to seat them.
Then I cut half circles in the ends of a couple pieces of plywood so I could use the same wooden blocks to hold the rear end while I assembled it. The upper bushings were already in the housing when it arrived. Last edited by 67-ls1; 03-13-2022 at 06:33 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode