Ray (shadowgray396) - repro dash

[Hank70SS]

Ray, got the dash in yesterday but ran into a few more challenges. The mounting posts that hold the heater control, glove box side were too long. The heater control and the filler plate above it did not sit flush on that side. Took a Dremel cutoff wheel and removed about 1/8", that was fun with the dash in the car.

Haven't started it yet but did start checking the gauges. The gas gauge appears to be ok. Amp gauge was working backwards. Pulled the connector out of the back of the gauge pod and swapped the wire. That was also a real challenge with the dash all bolted in. Temp gauge is pegged, not sure what that's about.

Had to stop before I finished checking things out. My son wants to borrow my pickup over Memorial Day weekend. He said he would wash and wax it for me. He used some 3M finish restorer wax on it. What a pain in the ass! My wife, my son and I worked on it for hours last night trying rub all the wax out.

Have to pour the coolant back in then I can fire it up today and finish it up.

[shadowgray396]

[QUOTE=Hank70SS;9811]Ray, got the dash in yesterday but ran into a few more challenges. The mounting posts that hold the heater control, glove box side were too long. The heater control and the filler plate above it did not sit flush on that side. Took a Dremel cutoff wheel and removed about 1/8", that was fun with the dash in the car.

Been having some of the same challenges on my dash. Been cutting and custom fitting on my also. Hope to have my gauges back by next week to finish installing them.