|
|
|
|
|
#1
12-08-2013, 05:05 PM
|
||||
|
||||
Got all the wiper parts in today. Just need to wire it up.
Also got my new shocks in the rear. Then removed the front coils and cut 2 coils off. It dropped it quite a bit. But it handles better than ever. Slightly harsh on big potholes/bumps. Nothing rubs. But ground to header clearance is just a couple inches. Need to go slow over speed bumps!    Sent from my iPhone using Tapatalk
__________________
I HATE RUST! 
|
|
#3
12-08-2013, 07:28 PM
|
|||
|
|||
|
Don't forget those coils will sag with age. It's going to be real low.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi
|
|
#4
12-09-2013, 06:17 PM
|
||||
|
||||
|
72 Driver NorthCarolina UNDER CONSTRUCTION
You would figure. But the rear are original and are still holding strong! We will see how long it takes to grind down my header flanges
 Got the wipers installed, wired and working !!!! Thanks again Ray  Now what I need is a picture of the windshield washer squirter location on a cowl induction hood. Who has some good photos for this big dummy?  Sent from my iPhone using Tapatalk
__________________
I HATE RUST!
|
|
#5
12-09-2013, 06:58 PM
|
|||
|
|||
|
http://www.chevelleforum.org/showpos...postcount=1354
You can see mine here, might have to zoom in to see exactly where they are. I currently have a domed hood like on your car.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi
|
|
#6
12-09-2013, 09:03 PM
|
||||
|
||||
|
Your welcome, also the squirters for a cowl hood and a flat hood are not the same. Make sure you have the correct ones. The cowl hoods squirters are longer.
http://www.ebay.com/itm/70-71-72-CHE...90537855662%26
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 12-09-2013 at 09:16 PM.
|
|
#7
12-10-2013, 05:48 PM
|
||||
|
||||
|
Did a review of this all the post in this thread today. Wow, I forgot all the work you have done to get it to this point. You should be very proud of all the work you have accomplished on this build. My hats off to you.
 
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#9
12-11-2013, 07:20 AM
|
||||
|
||||
|
Thank you all very much. I had a lot of help from yall! Cars running great
Ive looked over and over. Cant find any holes to mount squirters. Could somebody take a good photo of there placement and post it for my ignorant ass? Sent from my iPhone using Tapatalk
__________________
I HATE RUST!
|
 |
|
|
Hybrid Mode
