|
|
|
#81
10-07-2011, 08:29 AM
|
||||
|
||||
Started the final push to get the engine bay ready for the motor to go in. Need to figure out where the postive battery clip goes that holds the cable by the motor mount area.
__________________
Ray 1970 SS Chevelle Van Nuys Built 
|
|
#82
10-07-2011, 12:06 PM
|
||||
|
||||
 This is where mine is located. I don't know if it was ever removed before i got the car but it looks like the mounts have never been off. I hope this helps.
__________________
1970 Chevelle SS396 project with 454/M20 ps,pdb,U14 gauges, rear defroster 84 K5 Blazer 350/SM465 75 K5 Blazer 355/SM465/8 lugs
|
|
#83
10-07-2011, 01:51 PM
|
|||
|
|||
|
I'm going to be replacing the carpet, shifter boot/bezel and installing 3 point front seat belts this weekend. If I have the time I also want to replace the plain chrome valve covers and air cleaner top with ones with a red bow tie and black Chevrolet on them.
http://www.summitracing.com/parts/PRO-141-812/?rtype=10 http://www.summitracing.com/parts/PRO-141-906/?rtype=10
__________________
Mike
|
|
#84
10-07-2011, 02:10 PM
|
|||
|
|||
|
where did you get that 3 point seatbelt from? i was thinking about getting something but i wasnt sure on the safety of it
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
|
#85
10-07-2011, 02:23 PM
|
|||
|
|||
|
Quote:
http://www.retrobeltusa.com/ I'll be sure to give some feedback and pics.
__________________
Mike
|
|
#86
10-07-2011, 05:11 PM
|
||||
|
||||
|
Is that the same one that is in the Summit Christmas catalog ?
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#87
10-07-2011, 11:56 PM
|
|||
|
|||
|
thanks for the link! as far as what i did to the chevelle today i finally got the trunk looking almost stock i ran out of the splatter paint i hope my local stores have more
 if they do i can finish and put it the the way i want it and be done with the rear of my car for now 
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
|
#89
10-09-2011, 02:56 PM
|
|||
|
|||
|
finally the trunk looks like factory! just finished after 5 cans of splatter paint its done! now to let it dry and run the wiring harness to all of the lights and stuff cant wait!
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
|
#90
10-10-2011, 09:20 AM
|
||||
|
||||
|
Dropped mine off at the speedshop for some tuning and managed to squeeze 13 more horsepower out of it on the dyno. Not done but she is putting over 300 to the pavement which isn't bad out of a 350 running mechanical everything.
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA
|
 |
|
|
Linear Mode
