![]() |
|
#1051
|
|||
|
|||
|
Nothing.Waiting until I have time to restore the rear brakes and shocks
|
|
#1052
|
||||
|
||||
|
So do you have spiral shocks on the rear?
__________________
Ray 1970 SS Chevelle Van Nuys Built |
|
#1053
|
||||
|
||||
|
Quote:
You are going to have to take pics because I have a feeling that your brakes are probably cleaner than new ones.
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
|
#1054
|
|||
|
|||
|
Quote:
|
|
#1055
|
||||
|
||||
|
Ran my car at the track on Saturday.... Felt good to get behind the wheel again!!
http://www.youtube.com/watch?v=Hl5jsEibz-A
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA |
|
#1056
|
|||
|
|||
|
nice job man!
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
|
#1057
|
|||
|
|||
|
Quote:
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
|
#1058
|
||||
|
||||
|
Thanks guys!
Made 3 passes, all within 3 1/100s of each other. Best was an 11.22 @ 120.57 with a 1.632 60' I still don't feel like this car leaves very hard but I guess a mid to low 1.6 60 time isn't too bad for a 3995 pound car. Had a pretty strong headwind the entire day as well
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA |
|
#1059
|
|||
|
|||
|
Quote:
![]() Looks good Eric. I think I read on another post that somone was asking why the mph was the same as last motor configuration. Probably a pretty good head wind last Sat @ Silver Dollar. Track runs East/West and is was breazy. That will scrub off a couple mph's...
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
|
#1060
|
||||
|
||||
|
Well that and the MPH in question was from Paradise and their eyes at the end of the 1/8th seem to be a little off. Everything else picked up a good bit.
I stayed out of the right lane because as soon as I unloaded a tube chassis car spun and flipped about 5 times. Put it this way, the motor and trans left the track on a flat bed while the rest of the car was hauled away on something else. Seems everyone was struggling in the right lane Saturday.
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA |
![]() |
|
|